Справочник Пользователя для Crane Merchandising Systems Hot Beverage Maker 670
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001
Page - 1
November, 2002
INITIAL SETUP
I. LOCATION PREPARATION
After your machine is unpacked and placed near its permanent location, you need
to make sure you have the proper electrical and water service.
to make sure you have the proper electrical and water service.
ELECTRICAL POWER REQUIREMENTS
This merchandiser needs electrical power as shown in the following table.
NOTE
Each merchandiser should have its own electrical circuit.
Power Requirements
Country
Volts
Frequency (Hz)
Current (Amps
Canada
115
60
15
France
230
50
10
Germany
230
50
10
United Kingdom
230
50
10
United States
115
60
15
1. Check the Power Outlet
This merchandiser is supplied with a service cord for the country of use and is termi-
nated in a grounding type plug. The wall receptacle used for this merchandiser must be
properly polarized, grounded, and of the correct voltage. Operating the merchandiser
from a source of low voltage will VOID YOUR WARRANTY. Each merchandiser should
have its own electrical circuit and that circuit should be protected with a circuit breaker or
fuse conforming to local regulations.
This merchandiser is supplied with a service cord for the country of use and is termi-
nated in a grounding type plug. The wall receptacle used for this merchandiser must be
properly polarized, grounded, and of the correct voltage. Operating the merchandiser
from a source of low voltage will VOID YOUR WARRANTY. Each merchandiser should
have its own electrical circuit and that circuit should be protected with a circuit breaker or
fuse conforming to local regulations.
Voltage Check - Place the leads of a voltmeter across the LINE (LIVE) and
NEUTRAL terminals of the wall receptacle. The voltmeter should indicate 110-130
volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230 volt, 50 Hz
locations.
NEUTRAL terminals of the wall receptacle. The voltmeter should indicate 110-130
volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230 volt, 50 Hz
locations.
Polarity Check - Place the leads of a voltmeter across the LINE (LIVE) and
GROUND terminals of the wall receptacle. The voltmeter should indicate 110-130
volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230 volt, 50 Hz
locations.
GROUND terminals of the wall receptacle. The voltmeter should indicate 110-130
volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230 volt, 50 Hz
locations.
Noise Potential Check - Place the leads of a voltmeter across the NEUTRAL and
GROUND terminals of the wall receptacle. The voltmeter should indicate 0 volts
ac. A measurement greater than 1.5-2.0 volts ac could result in problems for the
merchandiser's electronic circuitry caused by electrical noise.
GROUND terminals of the wall receptacle. The voltmeter should indicate 0 volts
ac. A measurement greater than 1.5-2.0 volts ac could result in problems for the
merchandiser's electronic circuitry caused by electrical noise.
Any deviation from these requirements could result in unreliable performance from your
merchandiser.
merchandiser.