Справочник Пользователя для Clearsounds CST25

 

 

Page 6 

  

1.  Turn the phone over so that you are looking at the bottom of the phone.  Insert tabs at 

the thin end of the wall mount bracket into the holes at the 
rear of the phone bottom.  Press and latch the tabs at the 
thicker end of the wall bracket into holes at the front end of 
phone.  The back of the phone should then have two round 

plastic holes that can be used to hang your phone on the 
wall.   

 
2.  Use the two round holes to hang the phone on the wall plate on your wall.  
 
Important Note

:  If you do not wish to mount your phone on the wall, the Wall Mount 

 can be reversed to raise the angle of the phone's display when sitting on a table 

or desk. 
 
 

You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD 
viewing angle, move the rear edge of the LCD module up or down. 
                                

The display can be adjusted to suit the light level of your room and your viewing 
preference.  To make the contrast of the display lighter or darker, press the 

◑ button to 

the right of the screen until the desired contrast is reached. 

To adjust the handset receiver volume: 
1.  Lift the handset and listen to the dial tone. 
2. Press 

the 

 button to increase the receiver volume. 

3. Press 

the 

 down button to decrease the receiver volume. 

4.  Replace the handset when the desired receiver volume is reached.