Листовка для Arkon SM210

Consumer Hotline: 
(USA)    (800) 841-0884
(INT'L)   (626) 254-9005
               Mon-Fri. 9am-5pm, PST

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

SM210

CM910

CM043-ST-2

CM043-ST

CM090

CM090-2

SM020

SM020-2

Do not install Arkon products over an air bag cover or within the air 
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and/or 
air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to 
your car, your device, or yourself due to the installation or use of the 
pedestal mount.

AP020

Step 1.

Step 2.

Locate a safe flat surface on the dash 
or console to mount the pedestal. 
Clean the dash with the alcohol pad 
provided. Let the dash surface dry 
before applying the adhesive disc (G).

Push the pedestal suction cup (A) 
firmly to the disc (G). Flip the lever (B) 
down to secure the suction cup.

Step 1.

Step 2.

Step 3.

Step 4.

Pedestal Instructions  

 

Push the pedestal suction cup (A) firmly to the windshield. 
Flip the lever (B) down to secure the suction cup. 

Adjust the angle of the pedestal head by using both hands to 
bend the gooseneck (C).

Adjust the angle and rotation of the pedestal head by 
loosening the swivel-tightening ring (D).
 
Attach the device cradle to the dual-T tab head (E) by 
inserting the T-tabs into the T-slots (F). 

 

Step 1.

Step 2.

Step 3.

If necessary, adjust the support legs 
(J) by sliding them laterally. These 
provide support for your device.

Place device on the support legs (J) 
and squeeze the side grip arms (H) 
until they fit securely to the device.

Push the release button (I) in order 
to release the device from the cradle.  

CM047-S 

CM047-S2

CM043-ST-2

CM043-ST

AP020

CM047-S

CM047-S2

Flat side face up

Step 1.

Step 1.

Gently insert vent clips into vent louvres until the mounting clips 
are attached to the fin/blade of the vent. Adjust the support leg 
(M) vertically until it rests firmly along the bottom of the vent or 
dash surface below the vent.

 

 

Use caution when adjusting the swivel movement to avoid 
damaging your air vents.

 

(K)

(M)

(L)

(N)

(O)

(L)

Step 1. Adjust the swivel angle of the 

pedestal head by frimly 
holding the back of the 
pedestal (L), pulling out the 
pedestal head and twisting to 
the desired angle. Adjust the 
lateral angle of the pedestal 
head (N) by simply twising the 
head on the pivot axis (O). 

 

Attach the vent mounting clips (A) to the back of the pedestal (B) 
with the vent clips positioned with the flat sides facing up.