Справочник Пользователя для American Power Conversion 3-in-1 Wireless Mobile Router

Using the Wireless Security Screen

3-2

The following table describes the fields on the AP Mode Setup Screen.

This screen displays after clicking the Wireless Security button on the AP Setup screen. 
The default security setting is Disabled. No configuration is required. Data is not encrypted before transmission. One of the following 
screens displays, depending on the security system selected:

Select the region where the computer is located.

If using an ESS (Extended Service Set, with multiple access points) this ID is called an ESSID 

(Extended Service Set Identifier).
It is possible to change the SSID to a preferred value.
AP mode and AP/Router mode must use different SSIDs. Using the same SSID for both modes would 

confuse wireless clients.

If enabled, the SSID will broadcast its name to all wireless stations. 
On the computer, the APC 3-in-1 Wireless Mobile Router is listed as an Available Wireless Network, 

using the SSID above. If this wireless network is selected, the computer adopts this SSID

Select the desired mode:
g & b - Both 802.11g and 802.11b wireless stations will be able to use the APC 3-in-1 Wireless Mobile 

Router.
g only - Only 802.11g wireless stations can use the APC 3-in-1 Wireless Mobile Router. 

This selection determines which operating frequency will be used. The channel list changes according 

to the selected region.
Select the desired channel. Adjacent access points should use different channels to avoid interference.

The current security setting for wireless connections is displayed.
Note: The default value is Off, meaning no security.

Click this button to access the Wireless Security sub-screen, and modify the security settings as 

required.

This feature can be used to prevent unknown wireless stations from using this access point. To use this 

feature:
1. Enable this checkbox.

2. Click the Trusted Stations button to open a sub-window containing the Trusted Wireless Stations 

screen.

3. Enter details of the Trusted Wireless Stations. See the following section for further details.

Clicking this button copies the wireless settings, including the Trusted Station list, from the AP/Router 

screen to this screen.
This is only useful if the AP/Router Setup screen is already configured.
The SSID will not be copied. Each mode must use a different SSID. Using the same SSID for different 

modes would confuse wireless clients.