Справочник Пользователя для AMD PPC-L106T
16 PPC-L106T User Manual
2.3.2 Installing a primary 2.5" HDD (internal)
You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to the PPC-L106T's internal controller which uses a PCI local-
bus interface. The advanced IDE controller supports faster data transfer
rates and allows the IDE hard drive to exceed 528 MB. The following are
instructions for installation:
1.
disk drive to the PPC-L106T's internal controller which uses a PCI local-
bus interface. The advanced IDE controller supports faster data transfer
rates and allows the IDE hard drive to exceed 528 MB. The following are
instructions for installation:
1.
Detach the rear panel and remove.
2.
Place the HDD in the appropriate location inside the PPC-L106T,
and tighten the screws.
and tighten the screws.
3.
Connect the cable included in this package (1x44-pin to 1x44-pin)
from the HDD to the PC board (CN9). Make sure that the red/blue
wire corresponds to pin 1 on the connector, which is labeled on the
board. Plug the other end of the cable into the enhanced IDE hard
drive, with pin 1 on the cable corresponding to pin 1 on the hard
drive.
from the HDD to the PC board (CN9). Make sure that the red/blue
wire corresponds to pin 1 on the connector, which is labeled on the
board. Plug the other end of the cable into the enhanced IDE hard
drive, with pin 1 on the cable corresponding to pin 1 on the hard
drive.
Warnings!
(1) Plug the other end of the cable into the
HDD, with pin 1 on the cable corresponding to
pin 1 on the hard drive. Improper connection
will damage the HDD.
(2) Be careful not to damage the CPU board
with your tools!
HDD, with pin 1 on the cable corresponding to
pin 1 on the hard drive. Improper connection
will damage the HDD.
(2) Be careful not to damage the CPU board
with your tools!
Figure 2.2: Installing a primary 2.5" HDD (internal)