Листовка для Aero Mist Nozzle Fogging Kit 52469

Tape Measure
PVC Tubing Cutter
5/8" Open-End Wrench
9/16" Open-End Wrench

1.  Connect Flexible Nylon Tubing (56401) to outlet of high-pressure pump.
2.  Bury tubing approximately 6" underground. Cut Flexible Nylon Tubing (56401) with a PVC Tubing Cutter. Insert tubing into brass tee 

of the 3-Nozzle Fog Riser (52468) until it bottoms out in the fitting. Complete seal with one wrench turn of fitting. Continue by con-

necting tubing from one riser to next. Space risers 2-10 feet apart as desired. Closer spacing will result in denser fog. After the last riser, 

attach a short piece of tubing and terminate with the Brass End Plug (52513). 

3.  Flush system for several minutes before inserting nozzles. Install nozzles in 3 risers nearest the pump (hand tighten only) and flush again 

for one minute. Install nozzles in each additional riser, one-at-a-time and flush again until nozzles in all risers are installed.

MAINTENANCE
•  Nozzles require cleaning or replacement periodically. Clean nozzles by soaking in vinegar or calcium removal product overnight or 

replace as needed.

•  Winterize your misting system by draining water out of lines. Be sure all water is drained from Fog lines. This will prevent water from freez-

ing and damaging the fog line. This can be accomplished by forcing compressed air through the lines.

Warning! Fogging system is intended for outdoor use only.
•  Use normal tap water or soft water only. 
•  Do not exceed 1000 PSI,
•  Do not unscrew nozzles while under pressure
•  Do not touch nozzles when system is pressurized

For optimum performance of your new Aeromist 15-Nozzle Fog 

Kit (52469) we recommend the use of an optional 1000 PSI high-

pressure pump to create fog. This system is expandable with up 

to 30 (.012 size) nozzles using our  1000  PSI  Misting  Pump 

(60100K). Larger pumps are also available. Please see the en-

closed accessories brochure or visit www.aeromist.com for other 

available pumps, upgrades and accessories.

Q  How many nozzles can I use with 1000 PSI Misting Pump 

(60100K)?

A  30 nozzles and still maintain 800-1000 PSI range

Q  How much fog will this create?
A  Fog varies depending on temperature, humidity and spacing

Q  Does this create cooling?
A  Yes, this creates cooling when the fog evaporates.

Q  Can nylon be buried under concrete?
Y  Yes, recommend using sleeving.