Справочник Пользователя для Advantech Barcode Reader RS-485
2-2
ADAM-5000
Installation Guideline
2.1
General
Environmental Specifications
The following table lists the environmental specifications that general-
ly apply to the ADAM-5000 system (System kernel and
I/O modules).
ly apply to the ADAM-5000 system (System kernel and
I/O modules).
Specification
Rating
Storage temperature
-13 to 185°F (-25 to 85°C)
Ambient operating
temperature
14 to 158°F (-10 to 70°C)
Ambient humidity*
5 to 95%, non-condensing
Atmosphere
No corrosive gases
* Equipment will operate below 30% humidity. However, static
electricity problems occur much more frequently at lower humidity
levels. Make sure you take adequate precautions before you touch
the equipment. Consider using ground straps, antistatic floor cover-
ings, etc. if you use the equipment in low humidity environments.
electricity problems occur much more frequently at lower humidity
levels. Make sure you take adequate precautions before you touch
the equipment. Consider using ground straps, antistatic floor cover-
ings, etc. if you use the equipment in low humidity environments.
Power Requirements
Although the ADAM-5000 systems are designed for standard
industrial unregulated 24 V
industrial unregulated 24 V
DC
power supply, they accept any power
unit that supplies within the range of +10 to +30V
DC
. The power supply
ripple must be limited to 100 mV peak-to-peak, and the immediate ripple
voltage should be maintained between +10 and +30 V
voltage should be maintained between +10 and +30 V
DC
.
Diagnostic Indicators
Diagnostic indicators are located on the front panel of the ADAM
system. They show both normal operation and system status in your
remote I/O system. The indicators are:
system. They show both normal operation and system status in your
remote I/O system. The indicators are:
•
System status (PWR, RUN)
•
Communication status (TX, RX)
•
I/O module status