Справочник Пользователя для Advantech Barcode Reader RS-485
ADAM-5000
5-3
Chapter 5
Figure 5-1 Main screen
Normally you will use the Search command to scan the network.
Highlight the Search command on the menu bar and press <Enter> (or
simply press the "s" key). The "Search Installed Modules" window
will then appear to prompt you to enter the range it should scan. Input
a value between 0 and 256 decimal.
Highlight the Search command on the menu bar and press <Enter> (or
simply press the "s" key). The "Search Installed Modules" window
will then appear to prompt you to enter the range it should scan. Input
a value between 0 and 256 decimal.
Note:
When changing configuration, calibration or alarm
parameters, you should always make sure that a
window appears notifying you that the target module
has confirmed the changes.
parameters, you should always make sure that a
window appears notifying you that the target module
has confirmed the changes.
An asterix sign "*" before the module's address
indicates that the module is in the INIT* state.
indicates that the module is in the INIT* state.
Setup
Select Setup from the top bar and a selection bar will appear in the
status field. First, move the selection bar over the module you wish to
configure and select it by pressing <Enter>. A configuration screen
will appear with the setting available for its module type and the
status field. First, move the selection bar over the module you wish to
configure and select it by pressing <Enter>. A configuration screen
will appear with the setting available for its module type and the