Справочник Пользователя для AC International CT0-7TC-32
WIRING LEGEND
9
INSTRUCTION MANUAL
TERMINAL EQUIPMENT
STANDARD COLOR
Y1
First Heat Pump and AC
Yellow
G
Fan
Green
W2
First Stage Furnace
White
OBW
Reverse Valve - Second Stage Furnace
Orange
RH
24v
Red
Y2
Second Heat Pump and AC
Unknown
C
Common
Blue
H
Humidity Control
Unknown
DH
Dehumidify Control, Variable Fan Control
Unknown
RC
24v
Unknown
11 and 12
Not Used
NOTE: The above colors are standard in HVAC industry. The wiring should be
confirmed before installation
confirmed before installation
MOUNTING CLIMATOUCH
™
TO THE WALL
8
Climatouch
™
CT0-7TC-32
24V (RED)
2nd Stage Heat
1st Stage Heat (WHT)
Fan (GRN)
AC (YLW)
COMMON (BLUE)
1.
Make sure to turn off the power supply located at the electrical service panel.
All heating and cooling units should be OFF.
All heating and cooling units should be OFF.
2.
Separate the backplate from the thermostat by grasping the unit firmly at the
bottom lip and pulling gently until the two piece are apart.
bottom lip and pulling gently until the two piece are apart.
3.
Align the backplate to the wall.
4.
Mark the three locations for drilling the 3/16” holes required for the plastic
screw anchors.
screw anchors.
5.
Remove the backplate and drill the three 3/16” holes in these locations.
6.
Insert the plastic gyproc screws and ensure that they are snug in the wall.
7.
Securely mount the backplate to the wall with the 3 supplied screws.
8.
Make the appropriate wire connections based on the specifications of the
household HVAC unit(s). Please refer to Wiring Table to determine the appro-
priate wire connections.
household HVAC unit(s). Please refer to Wiring Table to determine the appro-
priate wire connections.
9.
Place the thermostat on the backplate by firmly but gently from the top aligning
the pins with the screw terminals.
the pins with the screw terminals.
10. Turn on the electricity at the electrical service panel.