Справочник Пользователя для Dolby Laboratories HSD 310

76

No power

No picture

No sound

The playback picture
has occasional

Brightness is 
unstable or noises 
are produced on
playback pictures

The DVD player
does not start
playback

Buttons do not work

The remote control
does not work
properly

The power plug is disconnected

The TV is not set to receive DVD
signal output

The video cable is not connected securely

The DVD video mode is not matched
with the TV

The audio cable is not connected securely

The power of the equipment connected with
the audio cable is turned off

The setting of output sound type is not correct. 

The disc is dirty.

It is in fast forward or fast reverse playback.

The copy protection’s effect.

No disc is inserted.

An unplayback disc is inserted.

The disc is placed upside down.

The disc is not placed within the guide.

A menu is on the TV screen.

The parental lock function is set.

Power supply fluctuations or other
abnormalities such as static
electricity may interrupt correct

The remote control is not pointed at
the remote sensor of the DVD player

The remote control is too far from
the DVD player

The batteries in the remote control
are exhausted

Connect the power plug into the wall outlet

Select the appropriate video input mode on 
the TV so the picture from the DVD player 
appears on the TV screen

Connect the video cable into the jacks 
securely

Refer to Connecting to a TV (page 10)

Connect the audio cable into the jacks

Turn on the equipment connected with the 
audio cable

Set the audio setting correctly.

Eject the discs and clean it.

Sometimes a small amount of picture 
distortion may appear. This is not 
malfunction.

Connect the DVD player to the TV directly.

Insert a disc.

Check the disc type and color system.

Place the disc with the playback side down.

Place the disc on the disc tray correctly 
inside the guide.

Clean the disc.

Press the SETUP button to turn off the menu 
screen. Cancel the parental lock function or 
change the parental.

Turn the power on or off with the POWER 
button. Or disconnect the power plug and 
insert it into the wall outlet again.

Point the remote control at the remote 
sensor of the DVD player

Operate the remote control within
about 7 m

Replace the batteries with new ones