Справочник Пользователя для Digidesign Control 24
Chapter 7: Overview and Basics
51
Meter Section Overview
Along the top of Control|24 are 24 stereo, 14-segment LED Channel meters at the top of the Fader sec-
tion, and six Output meters above the Main section.
tion, and six Output meters above the Main section.
Channel Meters
Pre-fader or post-fader level in-
dication of individual channels. Mono channels
activate the left side of the meter pair only.
activate the left side of the meter pair only.
Output Meters
Mirror the first six Output meters
of the primary Digidesign audio interface, show-
ing the current Pro Tools Meter path as selected
in the I/O Setup dialog. The Output meters dis-
play two-, four-, or six-channel output, depend-
ing on the current Stereo or Surround mode.
ing the current Pro Tools Meter path as selected
in the I/O Setup dialog. The Output meters dis-
play two-, four-, or six-channel output, depend-
ing on the current Stereo or Surround mode.
Control|24 meters follow Pro Tools Peak Indica-
tion preferences, and are identical in operation
to the meters on Digidesign audio interfaces.
tion preferences, and are identical in operation
to the meters on Digidesign audio interfaces.
To clear all clipped meters and held peaks:
■
Press the CLEAR PEAKS switch to the left of
the channel meters.
Channel Meter Options
Control|24 provides five meter options, avail-
able using the switches to the left of the channel
meters. These switches select the mode of meter-
ing for the 24 channel meters.
able using the switches to the left of the channel
meters. These switches select the mode of meter-
ing for the 24 channel meters.
To configure the channel meters:
1
Press the desired mode using the switches in
the METER SELECT section:
• Press PRE FADER to enable pre-fader meter-
ing.
• Press POST FADER to enable post-fader me-
tering.
• Press CLEAR PEAKS to clear all meters.
Figure 2.
Channel meters
Output meters
Meter options
Pro Tools on-screen 5.1 meters are always
mapped according to the Film standard
L, C, R, Ls, Rs, LFE. Output meters on
Control|24 and Digidesign audio inter-
faces, however, follow channel mapping in
I/O Setup. See “5.1 Surround Monitoring
and Control Room Options” on page 25.
mapped according to the Film standard
L, C, R, Ls, Rs, LFE. Output meters on
Control|24 and Digidesign audio inter-
faces, however, follow channel mapping in
I/O Setup. See “5.1 Surround Monitoring
and Control Room Options” on page 25.
At the present time, the INPUT and CHAN-
NEL switch is not implemented.
NEL switch is not implemented.