Справочник Пользователя для Digi Tech RP250

  

15

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to 

a flat EQ response (on most amps, this would be 0 or 5 on the tone controls).  Then follow the 

steps listed below.

1.  Turn the amp volume all the way down. 

2.  Connect the plug of the PS0913B power supply to the power jack on the rear panel of the 

RP250. 

3.  Connect the other end of the PS0913B power supply to an AC outlet.  Turn the RP250’s Mas-

ter Level knob (Knob 4) down to “0”. 

4.  Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal 

playing level. 

5.  Gradually increase the RP250’s Master Level knob to achieve the desired volume.