Справочник для Delta Tau GEO BRICK LV
Turbo PMAC/PMAC2 Software Reference
Turbo PMAC On-line Command Specification
277
individually modally address a coordinate system using the ADDRESS statement for subsequent
COMMAND statements, and the hardware control panel on a Turbo PMAC can separately select a
coordinate system for its hardware inputs.
COMMAND statements, and the hardware control panel on a Turbo PMAC can separately select a
coordinate system for its hardware inputs.
Note:
In firmware versions 1.934 and older, all communications ports addressed the
same coordinate system, so an &{constant} command sent over any port set
the addressed coordinate system for all ports.
same coordinate system, so an &{constant} command sent over any port set
the addressed coordinate system for all ports.
Example:
&
; Ask Turbo PMAC which C.S. is addressed
4
; Turbo PMAC reports that C.S. 4 is addressed
See Also:
I-variable I2
On-line commands #, #{constant},&{constant};
Program commands ADDRESS, COMMAND;
I-variable I2
On-line commands #, #{constant},&{constant};
Program commands ADDRESS, COMMAND;
&{constant}
Function:
Select port’s addressed coordinate system.
Scope:
Port specific
Syntax:
&{constant}
where:
{constant} is an integer from 1 to 16, representing the number of the coordinate system to be
addressed on this port
addressed on this port
This command makes the coordinate system specified by {constant} the addressed coordinate system
for the communications port over which this command is sent. This is the coordinate system that will act
on subsequent coordinate-system -specific commands sent over this port until a different coordinate
system is addressed with another &{constant} command.
for the communications port over which this command is sent. This is the coordinate system that will act
on subsequent coordinate-system -specific commands sent over this port until a different coordinate
system is addressed with another &{constant} command.
Other communications ports may be addressing different coordinate systems at the same time, as set by
&{constant} commands sent over those ports. In addition, each background PLC program can
individually modally address a coordinate system using the ADDRESS statement for subsequent
COMMAND statements, and the hardware control panel on a Turbo PMAC can separately select a
coordinate system for its hardware inputs.
&{constant} commands sent over those ports. In addition, each background PLC program can
individually modally address a coordinate system using the ADDRESS statement for subsequent
COMMAND statements, and the hardware control panel on a Turbo PMAC can separately select a
coordinate system for its hardware inputs.
Note:
In firmware versions 1.934 and older, all communications ports addressed the
same coordinate system, so an &{constant} command sent over any port set
the addressed coordinate system for all ports.
same coordinate system, so an &{constant} command sent over any port set
the addressed coordinate system for all ports.
Example:
&1B4R
; C.S.1 point to Beginning of Prog 4 and Run
Q
; C.S.1 Quit running program
&3B6R
; C.S.3 point to Beginning of Prog 5 and Run
A
; C.S.3 Abort program
See Also:
I-variable I2
On-line commands #, #{constant}, &
Program commands ADDRESS, COMMAND
I-variable I2
On-line commands #, #{constant}, &
Program commands ADDRESS, COMMAND