Инструкция С Настройками для DeLonghi Pinguino Air-to-Air PAC C100E

5

Thank you for choosing a De’Longhi product. Please take a few 
moments to read the instructions to avoid risks or damage to the 
appliance. 

1  air outlet grille
2  control panel
3  castor wheels
4   handles
5   filter
6   air intake grille
7  air exhaust hose housing
8  drainage hose with cap 
9   power cable
10   wall flange
11   air exhaust hose
12  window outlet
13   castor locks
14   remote control 
15   window bracket with locking pins
16   window bracket extension 

To avoid damage to the unit
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR 
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING 
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit 
has been on its side, oil needs to return to the compressor to 
ensure proper function.  Without allowing the unit this time (6-
24 hours) the unit may function for only a short time, and then 
the compressor will break down from lack of oil.

Electrical connection
Before plugging the appliance into the outlet, check that:
•  The  outlet’s  power  supply  corresponds  to  the  value

indicated on the rating label on the back of the appliance;

•  The  outlet  and  electrical  circuit  are  adequate  for  the

appliance;

•  The outlet is a 3-hole grounded outlet

 . If this is not 

the case, you must choose another outlet. Failure to 
follow these important safety instructions absolves the 
manufacturer of all liability.

it becomes necessary, the power cable must be replaced 
by a qualified professional only.
The instructions below will enable you to prepare your air 
conditioner for operation as efficiently as possible. Before use, 
make sure the air intake and outlet grilles are unobstructed.

For optimal results set-up in a double-hung window: 
1)  Place the bracket in the window sill, extend the bracket 

fully within the window frame, fix the bracket by using the 
pin then lower the window onto the bracket. (Should the 
window bracket be too large for the window.  The plastic 
can be cut with a saw by a qualified professional.)

2)  Fit the air exhaust hose in the housing  at the back of the  

appliance.  Insert it as shown in figure A.

3)  Connect the window outlet (12) to the other end of the 

exhaust hose.

4)  Insert the window outlet end of the exhaust hose into the 

slot of the window bracket (fig. B).

Other set-up methods:
•  Thanks to the locking pins, it’s possible to use the window

bracket also for sliding windows. Position the hole of the 
bracket so to allow a correct installation of the exhaust hose 
(see figure C).

•  If you have a casement window (figure D) follow steps 2 &

3 and place the window outlet (12) outside the window to 
exhaust the hot air.

A

B

C