Инструкция С Настройками для DeLonghi Gran Dama Avant ESAM 6700
11
Setting up the appliance
Information :
• Coffee has been used to factory test the
appliance and it is therefore completely
normal for there to be traces of coffee in the
mill.
The machine is, however, guaranteed to be
new.
• You should customize water hardness as
soon as possible following the instructions
in the section “Setting water hardness” on
page 20.
1. Plug the appliance into the power outlet and
(in models provided with main switch) place
the main switch on the back of the appliance
in the I position (fig. 1).
You must first select the language (the
languages scroll through at intervals of about
two seconds):
2. When English appears, press the oK icon for
3 seconds (fig. 2). Once the language has
been saved, the message “English installed”
is displayed.
Follow the instructions indicated by the
appliance:
3. “FILL TANK!”: remove the water tank, fill to
the MAX line with fresh water then replace in
the appliance (fig. 3).
4. “INSERT WATER SPOUT AND PRESS OK”:
Check that the hot water spout is inserted on
the nozzle and place a container underneath
(fig. 4).
Press the oK icon (fig. 2). “PLEASE WAIT...” is
displayed and the appliance begins to deliver
hot water.
The appliance ends the first start up procedure,
then the message “Turning off, please wait...” is
displayed and the appliance goes off.
The coffee maker is now ready for normal use.
Information: When using the appliance
for the first time, you need to make 4-5 cups of
coffee and 4-5 cappuccinos before the appliance
starts to give satisfactory results.
turnInG thE AppLIAnCE on
Information: In models provided with main
switch, before turning the appliance on, make
sure the main switch on the back of the appliance
is in the I position (fig. 1).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which
cannot be interrupted.
The appliance is ready for use only after
completion of this cycle.
Danger of burns! During rinsing, a little
hot water comes out of the coffee spouts and is
collected in the drip tray underneath.
Avoid contact with splashes of water.
• To turn the appliance on, press the button on
the left side of the machine
(fig. 5): the
message “Heating up... please wait” is dis
When heating is complete, the message changes
to: “Rinsing”. As well as heating the boiler, this
also heats the internal circuits by circulating hot
water.
The appliance is at temperature when the
message “STANDARD COFFEE standard taste”
is displayed.
turnInG thE AppLIAnCE oFF
Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be
interrupted.
Danger of burns! During rinsing, a little hot
water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
button
(fig. 5). The appliance performs the rinse cycle
then goes off.
Information: In models provided with
main switch, if the appliance is not used for an
extended period, place the main switch on the
back of the appliance in the 0 position (fig. 6).