Справочник Пользователя для DCS 36-48" BGB Grill BGB36-BQAR
25
SIDE BURNERS:
For proper lighting and performance
keep the burners clean. It is necessary
to clean the burners if they do not light
even though the igniter clicks, if there
has been a severe boil over, or when
the flame does not burn blue.
keep the burners clean. It is necessary
to clean the burners if they do not light
even though the igniter clicks, if there
has been a severe boil over, or when
the flame does not burn blue.
Be
certain all burner knobs are in the off
position before attempting to clean
the burners. The burners have been
designed for ease in cleaning. When
the grates and burners are cool,
remove the grate. The burner cap and
the brass port ring can easily be lifted
off.
position before attempting to clean
the burners. The burners have been
designed for ease in cleaning. When
the grates and burners are cool,
remove the grate. The burner cap and
the brass port ring can easily be lifted
off.
Wash these parts in hot soapy
water, rinse and dry thoroughly. The
burner caps are porcelain enamel,
follow the directions on the previous
page that were given for the burner
grates. A bristle brush can be used to
clean out the toothed burner ports, if
necessary.
burner caps are porcelain enamel,
follow the directions on the previous
page that were given for the burner
grates. A bristle brush can be used to
clean out the toothed burner ports, if
necessary.
After cleaning, it is
important to make sure the location
pins on the bottom side of the port
ring are properly aligned with the
corresponding holes in the base. In correct alignment will
produce a potentially dangerous flame and poor burner
performance (see Fig.34).
pins on the bottom side of the port
ring are properly aligned with the
corresponding holes in the base. In correct alignment will
produce a potentially dangerous flame and poor burner
performance (see Fig.34).
IGNITERS:
Wipe with a water dampened cotton swab. Be careful not
to damage the igniter (see Fig.35)
to damage the igniter (see Fig.35)
GRILL BURNER:
Remove the grill grates, then lift out the grill radiant tray.
Grasp the burner, pull it up and slightly to the rear of the
unit so the burner head comes off the brass orifice at the
front, angle the burner sideways, and remove.
Grasp the burner, pull it up and slightly to the rear of the
unit so the burner head comes off the brass orifice at the
front, angle the burner sideways, and remove.
Grill burner cleaning:
Clean the exterior of the burner with a wire brush. Clear
stubborn scale with a metal scraper. Clear any clogged ports
with a straightened paper clip. Never use a wooden toothpick
as it may break off and clog the port. Shake out any debris
through the air shutter. Use a flashlight to inspect the burner
inlet to ensure it is not blocked. If obstructions can be seen,
use a metal wire coat hanger that has been straightened out.
stubborn scale with a metal scraper. Clear any clogged ports
with a straightened paper clip. Never use a wooden toothpick
as it may break off and clog the port. Shake out any debris
through the air shutter. Use a flashlight to inspect the burner
inlet to ensure it is not blocked. If obstructions can be seen,
use a metal wire coat hanger that has been straightened out.
BURNER REMOVAL AND CLEANING
FIG. 36
FIG. 35
IGNITER (KEEP CLEAN)
FIG. 34
Brass Ring
Locating Pins
Locating Pins
Electrode
Main
Burner
Port
Ring
Burner
Port
Ring
Locating Notch
Burner
Base
Base
Venturi
Locating Holes
Cap