Инструкции Пользователя для BMW 2008 650i Coupe

Replacing components

224

Xenon lamps

The service life of these lamps is very long and
the probability of a failure is very low, provided
that they are not switched on and off an unusual
number of times. If one of these bulbs should
nevertheless fail, it is possible to continue driv-
ing with great caution using the fog lamps, pro-
vided traffic laws in your area do not prohibit
this.

Have work on the xenon lighting system
performed only by your BMW center or a

workshop that works according to BMW repair
procedures with correspondingly trained per-
sonnel. Due to the high voltage involved, there
is a danger to life and limb when work is carried
out improperly.

Parking lamps, roadside parking
lamps, daytime running lamps

The illustration shows the front left side of the
engine compartment.
35-watt bulb, H 8

Remove the cover cap

1 by pressing the tab

and removing the cover cap upward.

Turn the bulb holder to the left and remove.

Remove and replace the bulb.

Always wear gloves and eye protection –
the atmosphere inside the H8 bulb is

pressurized. Otherwise, there is a danger of
injuries if the bulb is accidentally damaged dur-
ing replacement.

Side-mounted turn signals

5-watt bulb, WY5W

Press against the front edge of the lamp
with the tip of your finger, then push it to the
rear, release the snap connection at the
front and take it off the trim strip.

Turn the bulb holder to the left by 90

5 and

remove.

Remove and replace the bulb.

Tail lamps

The parking lamps, tail lamps, brake
lamps, and turn signals use LED technol-

ogy. The backup lamps are equipped with long-
life bulbs. Please contact a BMW center in case
of a malfunction.

1 Turn signals
2 Roadside parking, tail and brake lamp
3 Reflector
4 Backup lamp