Справочник Пользователя для Braun 6550

 

If the cell unit is discharged, you may also shave 
with the shaver connected to the mains
(100 - 240 V 

 

Q

 

). (If the shaver should not run 

immediately, charge it with the switch on position 
«0» for approx. 1 minute.)

 

• We recommend to shave before washing, 

as the skin tends to be slightly swollen after 
washing.

• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction 

of beard growth.

 

• After shaving, switch the shaver off. Press the 

release button, take off the triple shaving frame 
and gently tap it out on a flat surface.

• Then thoroughly clean the duo cutter block

with the brush as well as the inner area of the 
pivoting head.

• A cleaning symbol appearing on the LCD display is 

supposed to remind you to thoroughly clean your 
shaver.

• About every four weeks, clean the duo cutter block 

with Braun cleaning agents.

 

To maintain optimum shaving performance,
you should replace the triple shaving frame or
the duo cutter block, when these parts are worn.

 

4

5

• The green charging light shows that the shaver is 

connected to the mains.

• The capacity of the cell unit is indicated by 20 % 

segments on the LCD display.
When all segments are visible on the LCD display, 
the cell unit is fully charged and the green charging 
light goes off.
A full charge will give up to 60 minutes of cordless 
shaving depending on your beard growth.
However, the maximum capacity will only be 
reached after several charging/discharging cycles.

• As of 9 minutes remaining capacity, the LCD 

displays the minutes left.
If the shaver is switched on, the red light is
flashing to remind you to recharge the cell unit. 
The red light goes off as soon as the capacity 
is down at «0».

• Cleaning symbol (see 5.1)

 

The shaver is delivered with the switch lock 
activated (position «

 

•

 

 lock»). Push the switch lock 

to position «

 

•

 

» before you shave for the first time. 

To avoid accidentally switching the shaver on, 
e. g. when travelling, push the switch lock to 
position «

 

•

 

 lock».

 

0 = Off

1 = Shaving with the pivoting head.

The pivoting cutting system automatically adjusts 
to every contour of your face.

2 = Shaving with the pivoting head locked at an angle 

(to permit shaving in difficult areas, e. g. under the 
nose).

3 = The long hair trimmer is activated 

(for trimming sideburns, moustache and beard).