Справочник Пользователя для Boss Audio Systems BR-900CD
16
Introduction to the BR-900CD
Memory Cards Supported by
Your BR-900CD
Your BR-900CD
The BR-900CD uses CompactFlash cards as the storage
media for recording and playback.
media for recording and playback.
The BR-900CD uses 32 MB to 1 GB CompactFlash cards with
a 3.3 V power supply.
a 3.3 V power supply.
For more on supported memory cards (CompactFlash) for
the BR-900CD, refer to “About Memory Cards” (separate
sheet).
the BR-900CD, refer to “About Memory Cards” (separate
sheet).
CompactFlash Type II cards are not compatible.
CompactFlash cards are available at your nearest computer
or digital camera shop.
or digital camera shop.
Formatting the memory card
(CompactFlash)
(CompactFlash)
CompactFlash cards bought at a computer shop, or ones
previously used with a digital camera cannot be used as is
with the BR-900CD.
previously used with a digital camera cannot be used as is
with the BR-900CD.
These CompactFlash cards must first be initialized for use
with the BR-900CD.
with the BR-900CD.
234
* CompactFlash and
are trademarks of SanDisk Corpo-
ration and licensed by CompactFlash association.
235
* BOSS Corporation is an authorized licensee of the
CompactFlash™ and CF logo (
) trademarks.
How to remove the card
protector
protector
To prevent theft of the memory card (CompactFlash), the BR-
900CD is shipped from the factory with a card protector.
900CD is shipped from the factory with a card protector.
fig.00-103
To remove the card protector, use the following procedure.
1. Make sure the card cover is closed, then the BR-900CD
over.
* When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.
* When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
2. Using a coin or
flathead screwdriver,
unscrew and remove
the coin screw from
the bottom panel.
unscrew and remove
the coin screw from
the bottom panel.
3. Pull out the card
cover in the direction
indicated by the
arrow.
indicated by the
arrow.
4. To prevent loss of the
card protector after it
is removed, place it as
shown in the figure.
Insert the card
protector in the slot as
indicated by the
arrow.
is removed, place it as
shown in the figure.
Insert the card
protector in the slot as
indicated by the
arrow.
5. Turn the BR-900CD
back over to its
original position.
original position.
Should you remove the screws, make sure to put them in a
safe place out of children’s reach, so there is no chance of
them being swallowed accidentally.
safe place out of children’s reach, so there is no chance of
them being swallowed accidentally.
Card Cover
Card Protector