Справочник Пользователя для Boss Audio Systems BR-900CD
59
Putting Multiple Tracks Together (Bounce)
Section 1
6. Use CURSOR [
] [
] and the TIME/VALUE dial to
select the recording-destination track/V-Track.
Here, set this to “34V2” (V-Track 2 of Tracks 3 and 4).
fig.01-602d
■ :
V-Tracks with recorded data.
❐ :
V-Tracks without data.
(When bouncing while recording in mono)
If you turn the TIME/VALUE dial at this time, the
screen for specifying the track for mono recording is
displayed.
screen for specifying the track for mono recording is
displayed.
fig.01-603d
7. After pressing [ZERO] to return to the time location
00:00:00-00.0, press [REC] and then press [PLAY] to start
bounce recording.
bounce recording.
8. When you are finished recording, press [STOP].
* During updating, “Keep power on!” appears in the upper line
of the display, while the lower line shows what is being
processed.
processed.
9. Lower all TRACK faders except those for Tracks 3 and
4, press [PLAY], and then check the sounds bounced to
Tracks 3 and 4.
Tracks 3 and 4.
* The pan for tracks 3 and 4, where the music was bounced, is
set all the way to the left and right respectively.
10. If you want to save the settings in the currently selected
song, hold down [STOP], and press [REC].
* During updating, “Keep power on!” appears in the upper line
of the display, while the lower line shows what is being
processed.
processed.
Bouncing Directly to a CD-R/RW Disc
(Direct CD Bounce)
(Direct CD Bounce)
With the BR-900CD, you can bounce data directly to a CD-R/
RW disc instead of the audio tracks. This is a convenient way
to keep a copy of song sketches after recording them.
RW disc instead of the audio tracks. This is a convenient way
to keep a copy of song sketches after recording them.
• The Rhythm and Tone Load functions cannot be used
when tracks are bounced directly to a CD. Only the
audio tracks are bounced.
audio tracks are bounced.
• Due to differences in the characteristics of CD-R/RW
discs, there is no way to ensure 100% error-free writing.
For this reason, the bouncing may be discontinued if an
error occurs in writing to the CD-R/RW disc. Never use
this feature with your important recordings.
For this reason, the bouncing may be discontinued if an
error occurs in writing to the CD-R/RW disc. Never use
this feature with your important recordings.
1. Prepare a blank CD-R/RW disc or a CD-R/RW disc to
which data has been written on the BR-900CD, but that
is not yet finalized (p. 143).
is not yet finalized (p. 143).
2. Place the CD-R/RW disc in the tray.
The CD-R/RW drive‘s indicator begins flashing.
Wait until the indicator stops flashing.
3. Press [REC MODE] a number of times until the
BOUNCE indicator lights.
The BR-900CD is switched to BOUNCE mode.
fig.01-604d
4. Use CURSOR [
] [
] and the TIME/VALUE dial to
select “CD.”
fig.01-605d
* If you wish to mix an input source as part of the bounce
recording, press [INPUT SELECT] to select the desired input
source. See “Selecting the Input Source and Bouncing the
Recording to a CD-R/RW” (p. 60).
source. See “Selecting the Input Source and Bouncing the
Recording to a CD-R/RW” (p. 60).
Recording destination