Справочник Пользователя для Bixolon SRP-F310/312

 

This sensor is set to the step4 position at the factory. If you find that there is not or too enough paper 

remaining on the roll when the near-end sensor is triggered, you can change the setting to the upper or 

Lower position as described below. 

Note: The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper 

roll with a core with an outside diameter of more than 18mm, it is better to change to the upper 

position(Rotate the tab at front side) as described below. 

1. Open the paper roll cover. 

2. Rotate the tab at front or rear Position.