Справочник Пользователя для Bionaire ULTRASONIC Humidifier BU5100
5. Place tank back on to the base. The tank will
immediately begin to empty into the base.
6. Plug the humidifier into a 120V electrical outlet.
OPERATING INSTRUCTIONS
1. To turn the humidifier on, switch the Slider Wheel (C) to
produce the highest moisture level (
). A lower setting
will produce lower moisture level but with longer run
time (for BU5000 and BU5100 only). The detailed
settings for each model are shown as below:
BU5000:
time (for BU5000 and BU5100 only). The detailed
settings for each model are shown as below:
BU5000:
Off (
O
) - Low (
) - High (
)
BU5100:
Off (
O
) - High (
)
BU5200:
Off (
O
) - On (
)
2. When the humidifier runs out of water, the transducer
will automatically shut off and the fan will keep running
to dry any residual water out of the base and chamber.
to dry any residual water out of the base and chamber.
3. Once the tank is empty, turn the the Slider Wheel to the
Off position (
O
) and unplug the unit.
4. Before refilling the tank, empty any residual water from
the base and tank. Follow daily maintenance instructions.
Figure 1
B
C
4
Model
Tank Capacity
(gallon)
(gallon)
Runs Up To (hrs)
BU5000
1.2
0.6
2.0
19
19
36
BU5100
BU5200
A. Tank
C. Slider Wheel
C. Slider Wheel
(not shown on
BU5000/BU5200
)
E. Humidifier Top Cover
(BU5200 Only)
B. Humidifier Base
D. Transducer
D. Transducer
(not shown on
BU5100/BU5200
)
F. Fan Outlet
(not shown on
BU5200
)
A
B
B
A
F
BU5200
BU5100
BU5000
E
A
D
F
PLEASE SAVE THESE
INSTRUCTIONS
INSTRUCTIONS
CONSUMER SAFETY INFORMATION
NOTE: This is an electrical appliance and requires attention
when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty
of humidity and additional moisture may cause damage.
NOTE: DO NOT block air inlet or outlet.
when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty
of humidity and additional moisture may cause damage.
NOTE: DO NOT block air inlet or outlet.
CORD AND PLUG INSTALLATION SAFETY
INSTRUCTIONS
INSTRUCTIONS
This appliance has a POLARIZED AC PLUG (one blade is
wider than the other). To reduce the risk
of electric shock, this plug is intended to
fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet.
of electric shock, this plug is intended to
fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR
DEFEAT THIS SAFETY FEATURE IN ANY WAY.
DEFEAT THIS SAFETY FEATURE IN ANY WAY.
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater
than the rating of the humidifier. Care must be taken to
arrange the extension cord so that it will not drape over the
countertop or tabletop where it can be pulled on by
children or accidentally tripped over.
reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater
than the rating of the humidifier. Care must be taken to
arrange the extension cord so that it will not drape over the
countertop or tabletop where it can be pulled on by
children or accidentally tripped over.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched off (the Slider Wheel
(C) is turned all the way towards "
O
" position).
2. Select a location for your humidifier, on a flat level
surface about 4 inch away from the wall. DO NOT
place the humidifier on a finished floor or near furniture,
which can be damaged by too much moisture or water.
Place on a moisture resistant surface.
place the humidifier on a finished floor or near furniture,
which can be damaged by too much moisture or water.
Place on a moisture resistant surface.
3. Remove the tank from the main housing.
4. Bring the tank to the sink, turn upside down and twist off the
4. Bring the tank to the sink, turn upside down and twist off the
tank cap by turning counter clockwise. Fill tank with cool,
fresh tap water. DO NOT fill with warm water as this may
cause leaking. Replace the cap on tank FIRMLY. The tank
capacity and run time for each model are listed below:
fresh tap water. DO NOT fill with warm water as this may
cause leaking. Replace the cap on tank FIRMLY. The tank
capacity and run time for each model are listed below:
3
BU5000_5100_5200-U_07EM2.qxd 7/23/07 13:49 Page 5