Инструкции Пользователя для Biostar TForce4 SLI
Biostar
T-Series
TForce4
SLI
User’s Manual
9
Headers for USB Ports at Front Panel: JUSB1~JU SB3
This connector allows user to connect additional USB cables at PC front panel,
and also can be connected with internal USB devices, like USB card reader.
and also can be connected with internal USB devices, like USB card reader.
Pin
Assignment
1 +5V
(fused)
2 +5V
(fused)
3 USB-
4 USB-
5 USB+
4 USB-
5 USB+
6 USB+
7 Ground
7 Ground
8 Ground
9 Key
9 Key
9
1
2
10
JUSB1
JUSB2
JUSB3
10 NC
Case Open Header: JCI1
This connector allows system to monitor PC case open status. If the signal has
been triggered, it will record to the CMOS and show the message on next boot-up.
been triggered, it will record to the CMOS and show the message on next boot-up.
Pin
Assignment
1 Case open signal
1 2
2 Ground
Clear CMOS Header: JCMOS1
By placing the jumper on pin 2-3, it allows user to restore the BIOS safe setting
and the CMOS data, please carefully follow the procedures to avoid damaging the
motherboard.
and the CMOS data, please carefully follow the procedures to avoid damaging the
motherboard.
1
3
Pin 1-2 Close:
Normal Oper ation (default).
1
3
1
3
Pin 2-3 Close:
Clear CMOS data.
Clear CMOS Procedures:
※
1. Remove AC power line.
2. Set the jumper to “Pin 2-3 Close”.
3. Wait for five seconds.
4. Set the jumper to “Pin 1-2 Close”.
5. Power on the AC.
6. Reset your desired password or clear the CMOS data.
2. Set the jumper to “Pin 2-3 Close”.
3. Wait for five seconds.
4. Set the jumper to “Pin 1-2 Close”.
5. Power on the AC.
6. Reset your desired password or clear the CMOS data.