Инструкции Пользователя для Biostar K8VGA-M
K8VGA-M
18
4.3 T
ROUBLESHOOTING
Probable Solution
1.
No power to the system at all
Power light don’t illuminate, f an
inside power supply does not
turn on.
Power light don’t illuminate, f an
inside power supply does not
turn on.
2.
Indicator light on key board
does not turn on.
does not turn on.
1.
Make sure power cable is
securely plugged in.
securely plugged in.
2. Replace
cable.
3.
Contact technical support.
System inoperativ e. Keyboard lights
are on, power indicator lights are lit,
and hard driv e is spinning.
are on, power indicator lights are lit,
and hard driv e is spinning.
Using even pressure on both ends of
the DIMM, press down firmly until the
module snaps into place.
the DIMM, press down firmly until the
module snaps into place.
System does not boot from hard disk
driv e, can be booted f rom optical
driv e.
driv e, can be booted f rom optical
driv e.
1.
Check cable running from disk to
disk controller board. Make sure
both ends are securely plugged
in; check the driv e type in the
standard CMOS setup.
disk controller board. Make sure
both ends are securely plugged
in; check the driv e type in the
standard CMOS setup.
2.
Backing up the hard drive is
extremely important. All hard
disks are capable of breaking
down at any time.
extremely important. All hard
disks are capable of breaking
down at any time.
System only boots f rom optical driv e.
Hard disk can be read and
applications can be used but booting
from hard disk is impossible.
Hard disk can be read and
applications can be used but booting
from hard disk is impossible.
1.
Back up data and applications
f iles.
f iles.
2.
Ref ormat the hard driv e.
Re-install applications and data
using backup disks.
Re-install applications and data
using backup disks.
Screen message says “Invalid
Conf iguration” or “CMOS Failure.”
Conf iguration” or “CMOS Failure.”
Rev iew system’s equipment. Make sure
correct inf ormation is in setup.
correct inf ormation is in setup.
Cannot boot system after installing
second hard driv e.
second hard driv e.
1.
Set master/slave jumpers
correctly.
correctly.
2.
Run SETUP program and select
correct driv e types. Call the drive
manuf acturers f or compatibility
with other drives.
correct driv e types. Call the drive
manuf acturers f or compatibility
with other drives.