Справочник Пользователя для Benq Projector MP670
Operation
45
English
Controlling the projector through a Lan
environment
environment
Lan Control Settings allow you to manage the projector from a computer using a web
browser when the computer and the projector are properly connected to the same local area
network.
browser when the computer and the projector are properly connected to the same local area
network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1.
Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
and the other end to the RJ45 port.
2.
Press MENU/EXIT and then press
/
until the SYSTEM SETUP: Advanced
menu is highlighted.
3.
Press
to
highlight
Lan Control Settings and press MODE/ENTER. The Lan
Control Settings page displays.
4.
Press
to
highlight
Control By and press
/
to select RJ45.
5.
Press
to
highlight
DHCP and press
/
to select On.
6.
Press
to
highlight
Apply and press MODE/ENTER.
7.
Re-enter the Lan Control Settings page. The Projector IP Address, Subnet Mask,
Default Gateway, and DNS Server settings will display. Note down the IP address
displayed in the Projector IP Address row.
Default Gateway, and DNS Server settings will display. Note down the IP address
displayed in the Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
Network State
Network
DHCP
Projector IP Address
Projector IP Address
Subnet Mask
Dedault Gateway
Dedault Gateway
DNS
DNS
Apply
Apply
Disconnect
Off
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
MENU Back