Инструкции Пользователя для Behringer Europack UB2222FX-Pro

EURORACK UB2442FX-PRO/UB2222FX-PRO/UB1832FX-PRO/UB1622FX-PRO User Manual

UB1832FX-PRO

Fig. 3.1: The graphic stereo equalizer of the UB1832FX-PRO

The graphic stereo equalizer allows you to tailor the sound to the room acoustics.

EQUALIZER
Use this switch to activate the graphic equalizer.

MAIN MIX/MONITOR
This toggles the graphic equalizer between the main mix and the monitor mix. 

With the switch up (not depressed), the equalizer is active in stereo on the main 

mix, and inactive on the monitor mix.
When the switch is depressed the equalizer is active in mono on the monitor mix, 

and inactive on the main mix.

The switch turns on the FBQ Feedback Detection System. It uses 

the LEDs in the frequency band faders to indicate the critical 

frequencies. On a per-need basis, lower the frequency range 

in question somewhat in order to avoid feedback. The graphic 

stereo equalizer has to be turned on in order to use this function.

Feedback is particularly common when stage monitors (“wedges”) 

are concerned, because monitors project sound in the direction of microphones. 

Therefore, you can also use the FBQ Feedback Detection for monitors by placing 

the equalizer in the monitor bus (see MAIN MIX/MONITOR).

Here you can find a list of all presets stored in the multi-effects 

processor. This built-in effects module produces high-grade 

standard effects such as reverb, chorus, flanger, delay and various 

combination effects. Use the Aux Send FX on the channels and the 

Aux Send FX master control to determine the input signal of the effects processor.
The built-in stereo effects processor has the advantage that it does not need to 

be wired up. This excludes the danger of humming or level mismatch right from 

the start and thus considerably facilitates use.
These effect presets are classical “mixing effects”. If you move the STEREO AUX 

RETURN FX control, you mix the channel signal (dry) and the effect signal. You can 

control the balance between the two signals with the channel fader and the 

STEREO AUX RETURN FX control.

All Models

24–BIT A/D & D/A CONVERTER

24–BIT DUAL ENGINE DSP

LEVEL

Fig. 4.1: Digital effects module

FX OUT
Mixing consoles UB2222FX-PRO and UB2442FX-PRO have a separate output 

for the effects device, which is unbalanced and stereo (tip = left signal; 

ring = right signal; sleeve = ground/shielding). Thus, you can record, 

for example, a vocal track enhanced with reverb in parallel to a “dry” vocal track; 

when doing the mix-down later on, you can freely determine the amount of 

reverb added.

FX FOOTSW
Connect a standard foot switch to the foot switch jack and use this to switch 

the effects processor on and off. A light at the bottom of the display indicates 

wheater the effects processor has been muted by the foot switch.

LEVEL
The LED level meter on the effects module should display a sufficiently high 

level. Take care to ensure that the clip LED only lights up at peak levels. If it is 

lit constantly, you are overloading the effects processor and this could cause 

unpleasant distortion.

PROGRAM
You can select the effect preset by turning the PROGRAM control. The display 

flashes with the number of the current preset. To recall the selected preset, 

press on the button; the flashing stops. You can also recall the selected preset 

with the foot switch.