Справочник Пользователя для Barco Projector 26-0313000-00

Program and Source Link Connections

This section provides instructions for connecting Program Link and Source Link 
connections (DVI-I) in a variety of Encore configurations.

Left justification means that the first pixels of the projected image begin immediately at the 
left, and that unused source material is removed from the far right of the image.  A two-
projector sample is illustrated below.

Figure 3-13.  Left Justification

Please note:

Left justified systems are connected in daisy-chain fashion. 

Up to 32 Encore processors are supported (both VP and VPx).

A VP must be used as processor 1 (master).  Thereafter, either a VP or VPx can 
be used. 

„

Use the following steps to connect Program and Source Links for left justification:

Connect the Program Link Out connector on processor 1 to the Program Link In 
connector on processor 2, as illustrated below.

Figure 3-14.  Program Link Connections

Repeat the procedure for all remaining processors in your configuration.  

Secure all cable connections tightly to ensure reliable 
operation.  This is important especially for the Program and 
Source links — as box-to-box synchronization is relayed in 
these cables for wide screen setups.

Projector 1

Image

Unused

Source

Material

Image

Overlap

Region

Projector 2

Image

Processor 1

(VP only)

Program 

Link Out

Program 

Link In

Processor 2

(VP or VPx)

Program 

Link Out

Program 

Link In

Processor [n]

(VP or VPx)

Program 

Link Out

Program 

Link In