Справочник Пользователя для Barco Projector Accessories R9840170

Menu Setup

The bold items do not appear bold on the screen. This is only done to grasp the attention of the

reader.

The two upper lines are a copy of the local LCD of the projector when in Remote Mode or the

contents of the Lamp information module when in Lamp Read Mode.

In case of a 6000 series LCD projector these two lines are not displayed.

The third line is in most case a status line, showing all kinds of status information of the Remote

Control.

Different status messages:

ADDR=

displays the address of the remote  (for example 1).

BAT=ACT

the remote is working on batteries, there is no supply via external power source.

BAT=LOW

the battery is running low (see "<Installation Setup" for charging procedure)

RF=ACT

the remote is working with wireless communication.

RF=LOW

the remote is working with wireless communication but has not etablished a good

communication link.

INTERNAL TEMP TOO HIGH

The third line may  also display the actual Internal Menu main title.

The fourth line is a command line, showing possible key commands.

It also displays the item of the Internal menu.

The Rugged Remote Control's Internal Menu is accessible by pressing the <ADJ> button.

Pressing twice <ADJ>  gives access to the projector's Menu or exits the Menu.

NO COMMUNICATION

ADDR=1    BAT=LOW/RF=LOW
PRESS <ADJUST> TO ENTER

Line 1

Line 2

Line 3

Line 4

Flowchart 1

MAIN SCREEN

RRC INTERNAL MENU

ADJ

ADJ

MAIN SCREEN

ADJ command not sent to projector

2

nd 

ADJ command sent to projector