Справочник Пользователя для Barco DICOM THEATER LITE MGP D5

Troubleshooting

MGP D5 Dicom Theater Lite

103

Windows 2000 display resolution

Tip: These instructions apply to both Windows

®

2000 and 

®

XP.

Setting the resolution of your MGP D5 Dicom Theater display

In order to set the resolution of your MGP D5 Dicom Theater 
display you must be logged in using an account with 
administrator privileges.

1. To set the resolution of your MGP D5 Dicom Theater 

display(s) right click on the desktop and select 
“Properties”. 

2. Select the “Settings” tab.

3. Select the rectangle that represents the first MGP D5 Dicom 

Theater display attached to the B

ARCO

M

ED

 2MP2CP display 

controller you are working with.

NOTE: If you are using the VGA capabilities of your B

ARCO

M

ED

 

2MP2CP display controller, the resolution for the first display 
may be set to a VGA resolution of “640 x 480” pixels with 16 
colors and a default refresh rate. If your BarcoMed 2MP2CP 
controller is not running VGA, the display may not be 
enabled yet. To enable the display, check the “Extend my 
Windows desktop onto this monitor” checkbox, but do NOT 
click the “Apply” button at this time.

4. Select the “Adapter” tab and then click on the “List All 

Modes” button. Select the resolution and refresh rate that 
your MGP D5 Dicom Theater display supports from the dialog 
box and click “OK”.

5. Click “OK” on the bottom of the Adapter Control Panel. If the 

“OK” button on the bottom of the Adapter Control Panel is 
not visible, press the “TAB” key once and then press 
“CTRL”+“Enter” to select “OK”.

6. Click “OK” in the “Windows will now apply your new 

desktop settings” dialog box. Your MGP D5 Dicom Theater