Справочник Пользователя для Bosch Appliances Radio SC3100

© 2004 Bosch Security Systems 

Page 19 

90026-201D 

This section describes the installation procedures for the SC3100 Radio Communicator. 

Mount the SC3100 at the location determined from the considerations discussed in Section 3.0. The total weight 
of the SC3100 is about one pound (0.5 kg) with the internal 12 VDC battery installed. 

The SC3100 is normally installed in an upright position in the bottom and inside of the host alarm panel 
enclosure (see Figure 3). 

SC3100

HOST ALARM PANEL

SAFECOM

SAFECOM ANTENNA
CONNECTOR

FACTORY SUPPLIED
RF COAXIAL CABLE

HOST ALARM PANEL

BATTERY

SAFECOM SC3100
RADIO COMMUNICATOR

Each SC3100 Radio Communicator unit is shipped from Bosch Security Systems with a 20 in. (50.8 cm) antenna 
coaxial cable assembly to mount the antenna directly on the host alarm panel enclosure (as shown above). The 
unit is also shipped with a 2" x 2" antenna mounting L-bracket for mounting the antenna directly on the side of 
the host alarm panel or for remote installation of the antenna. 

If mounting the antenna directly on the host alarm panel, use the attached antenna coaxial cable assembly to 
connect the SC3100 radio communicator to the antenna (on the top of the host alarm panel enclosure). See the 
following figure: 

HOST ALARM
PANEL
ENCLOSURE
WITH KNOCK-
OUT REMOVED

MOUNTING WASHER

MOUNTING WASHER

ANTENNA CONNECTOR