Справочник Пользователя для Bay Technical Associates BayTech DS62
DS62-Network, DS62-MD4 Network/Modem Host Module
15
Unit Configuration Menu
The configuration menu allows the admin user to establish the parameters the DS-Series will operate.
Select the number of the host module and the following menu is displayed:
Configuration Status
The Status menu displays the modules installed and the current configuration of the host module. The
following are the factory default settings:
following are the factory default settings:
Accept changes ? (Y/N) :y
Changes accepted.
Changes accepted.
Configuration
DS62 module #1..........1
DS74 module #2..........2
DS-RPC module #5..........3
Enter Request :
DS62 module #1..........1
DS74 module #2..........2
DS-RPC module #5..........3
Enter Request :
Copyright(C) Bay Technical Associates 2006
DS62-MD4 Ethernet Host module
Revision F 2.10.05 Module 1
Hardware 1.01 Serial number 509 colilo version 1.05.01
Status..........................1 Current setting of the module
Serial Port Configuration.......2 Setup the port configuration menu
Serial Port Device Name.........3 Name the port
Attention Character.............4 Pressing the attention character 5
DS62-MD4 Ethernet Host module
Revision F 2.10.05 Module 1
Hardware 1.01 Serial number 509 colilo version 1.05.01
Status..........................1 Current setting of the module
Serial Port Configuration.......2 Setup the port configuration menu
Serial Port Device Name.........3 Name the port
Attention Character.............4 Pressing the attention character 5
consecutive times will return back to the
main
menu.
Disconnect Timeguard............5 If more data is received within the delay
period, the DS series treats the
character as data, not an attention
character; thereby preventing unwanted
port
disconnection.
Connect Port ID Echo............6 Enable port echo by name or module&port#
Login Setup.....................7 Login menu Access/Users/Direct Port
Login Setup.....................7 Login menu Access/Users/Direct Port
Connection/Radius/TACACS
Network Port Configuration......8 Network Setup IP Address
Module Name.....................9 Enter a name for the module
DS Management............... ..10 Set up Voltage/Current/Sensor thresholds
Firmware / Config Download.....11 Updates by FTP & Reset to Factory Config
Exit.........................X,CR
Enter Request :
Module Name.....................9 Enter a name for the module
DS Management............... ..10 Set up Voltage/Current/Sensor thresholds
Firmware / Config Download.....11 Updates by FTP & Reset to Factory Config
Exit.........................X,CR
Enter Request :