Справочник Пользователя для Barco Laser Pointer 26-0405000-00

Quick Input Setup Procedure

e.  Press {BACK} to return to the Output Menu.

3.   Press {SETTINGS} to display the Settings Menu.

a.  Scroll to the Sync Out line and set the desired sync value.   

b.  Scroll to the SOG line and enable or disable “sync on green” as required.  

c.  Scroll to the Gamma line and set output gamma to match your projector.

d.  Press {BACK} to return to the Output Menu.  

4.  Press {SAVE} to save all output settings in the output file.

5.  At the projector itself, perform additional setup procedures (e.g., color balance, 

alignment, etc.) as required.  

6.  When all procedures are complete, press {TEST PATTERN} to access the Test 

Pattern Menu, and turn off the test pattern and raster box. 

Please continue with the “

” section on page 89.

This procedure enables you to quickly acquire and save inputs.  Please note the following 
important prerequisites:

Ensure that you have completed your input connection chart.  In Chapter 3, refer 
to the “

” section on page 24 for details and instructions.

Ensure that all inputs are properly connected to the chassis.

Ensure that the system has been “factory” reset.  Refer to the “

” section on page 87 for details.  After a factory reset, the 

PIP button will 

be blinking, and no sources will be selected on the 

Source Selection Bus.

„

Use the following steps to perform a quick input setup:

1.  On the Source Selection Bus, press an input button, then press TRANS to view 

the source on Program.  The system will attempt to acquire the input, and the 
Input Acquisition Menu will be displayed.  

2.  If the “Source Acquired” message appears, the acquisition was successful.  

Press {

SAVE} to display the Input Menu for the selected source, which enables 

you to fine tune the input if desired.  Refer to the “

” 

section on page 90 for details.

3.  If an error message appears on the Input Acquisition Menu, first check all cable 

connections.  You can then:

Press {

FORCE ACQUIRE} to re-attempt acquisition, or ...

Press {

INPUT} to display the Input Menu without performing a FORCE 

ACQUIRE, and manually adjust input parameters. 

4.  Repeat from step 1 for all remaining inputs.  

If you do not press {

SAVE} for a selected input, the Input 

Acquisition Menu will continue to appear whenever that 
source button is pressed.