Справочник Пользователя для Woodstock W1099
- 15 -
Woodstock Intl., Inc. W1099
XIV. TROUBLESHOOTING
E. FIT TOO TIGHT
OR TOO LOOSE
If you find the fit to be about right in every other
aspect, but it is simply a little too tight or too
loose, the depth of the router bit is probably mal-
adjusted.
aspect, but it is simply a little too tight or too
loose, the depth of the router bit is probably mal-
adjusted.
1. If the fit is too tight, decrease the protrusion
of the router bit from the base.
2. If the fit is too loose, increase the protrusion
of the router bit from the base.
D. OFFSET EDGES
If the side piece edge is not aligned with the front
or back piece edge, the edges are offset. Figure
18.
or back piece edge, the edges are offset. Figure
18.
Cause: The side stops are not set correctly.
Remedy: Measure the amount of offset on the two
test pieces and adjust the front side stop accord-
ingly. The front side stop must be offset from the
top side stop by the exact width of the fingers on
the template you are using. Ensure that the front
side stop remains square to the workpiece mounted
test pieces and adjust the front side stop accord-
ingly. The front side stop must be offset from the
top side stop by the exact width of the fingers on
the template you are using. Ensure that the front
side stop remains square to the workpiece mounted
on top of the jig.
F. UNEVEN FIT
If the side piece fits either excessively or protrudes
at one edge and not the other, the fit is uneven.
Figure 19.
at one edge and not the other, the fit is uneven.
Figure 19.
Cause: The fence is not parallel to the edge of the
workpiece or the template is not parallel to the
edge of the workpiece.
workpiece or the template is not parallel to the
edge of the workpiece.
Remedy: Adjust the fence or template in the
desired direction until it is parallel to the edge of
the workpiece. For the highest degree of accuracy,
clamp the two workpieces in the front of the jig
so they are positioned against the two side stops
and measure the distance between the edge of the
workpiece and the edge of the fence or template.
desired direction until it is parallel to the edge of
the workpiece. For the highest degree of accuracy,
clamp the two workpieces in the front of the jig
so they are positioned against the two side stops
and measure the distance between the edge of the
workpiece and the edge of the fence or template.
Adjust the fence or template so the measurement
on the other end of the jig equals the first. Re-
check the first measurement in case it changed
during adjustment.
on the other end of the jig equals the first. Re-
check the first measurement in case it changed
during adjustment.
Figure 19 shows uneven fit.
Figure 18 shows offset edges.