Справочник Пользователя для Taylor Electric Grill QS22
18
Models QS10 & QS22
Operating Procedures
Step 4
Place the release material clips over the release
material sheet, pressing them into place over the
release material bar at the top of the platen.
Place the release material clips over the release
material sheet, pressing them into place over the
release material bar at the top of the platen.
Figure 12
Step 5
Check the alignment and tightness of the release
material against the upper platen.
Check the alignment and tightness of the release
material against the upper platen.
Step 6
Repeat steps 1 through 5 for the remaining upper
platen(s) on the QS22.
Repeat steps 1 through 5 for the remaining upper
platen(s) on the QS22.
Note: It is not necessary to change the release
material if small pin holes develop.
material if small pin holes develop.
The release material must be changed when:
S
Product sticks to the release material.
S
Carbon builds up, causing problems in taste
or appearance.
or appearance.
S
There is a tear in the release material in the
cooking area.
cooking area.
S
The release material substance is worn from
the release material sheet.
the release material sheet.
S
The temperature of the upper platen drops
more than 10_F. (5.6_C.) from the tempera-
ture recorded when the release material was
removed.
more than 10_F. (5.6_C.) from the tempera-
ture recorded when the release material was
removed.
Note: Temperature checks should only be con-
ducted with the release material sheets removed.
ducted with the release material sheets removed.
Note: Rotate and reverse the release material
sheets on a daily basis.
sheets on a daily basis.
Care of Release Material Sheets
S
DO NOT fold or crease.
S
DO NOT touch with any sharp object or
abrasive.
abrasive.
S
DO NOT hose with hot water or soak in
water.
water.
S
DO NOT place under other objects.