Справочник Пользователя для Fujitsu ETERNUSmgr P2X0-0202-01EN

Chapter 2 Setup

P2X0-0202-01EN ETERNUSmgr User Guide -Introduction-

■

Polling Interval

This parameter is used to control polling (periodically checking the status) of a target device.
Set the polling interval in units of seconds within the range of 1 ~ 65535.

[Default value]

300

[Parameter]

POLLING_TIME (1-65535)

[Example]

POLLING_TIME=300

This specifies the Polling Interval (time between the start of one poll to the next).
Due to network or device load the actual polling time may exceed the set time. In such cases, the start of
the next polling time is delayed until the previous polling finishes:

When the actual polling finishes within the scheduled polling time:

When the actual polling exceeds the scheduled polling time:

Caution:

Unless there is some special reason to change this parameter, it is recommended to keep the
default. For this reason the parameter is initially commented out.

■

Target Type

Sets the target device type. Two parameters are provided: TARGET_TYPE and TARGET_FLAG
These parameters cannot be omitted. ETERNUSmgr will not start if these parameter have not been set.

[Parameter]

TARGET_TYPE (up to 256 characters)

[Example]

Any character string can be used to describe the target device type.
When the type of target device is ETERNUS3000:

TARGET_TYPE=ETERNUS3000

150 sec

200 sec

300 sec

Per schedule

Scheduled polling
interval
Actual polling
interval

Scheduled start OK

400 sec

150 sec

450 sec

300 sec

Schedule
recalculated

Scheduled polling
interval
Actual polling
interval

Per schedule

Schedule
recalculated

Scheduled
start NG

Delayed start

Holding