Справочник Пользователя для Brother XL-2610i
23
1
4
Pull down the needle threader lever as much
as possible, and then turn the lever toward the
back of the machine (away from you). Make
sure that the hook passes through the eye of
the needle and grabs the thread.
as possible, and then turn the lever toward the
back of the machine (away from you). Make
sure that the hook passes through the eye of
the needle and grabs the thread.
1 Hook
2 Thread
2 Thread
• Hold the thread in front of the needle to
make sure that the hook grabs it.
5
While lightly holding the thread, turn the
needle threader lever toward the front of the
machine (toward you). The hook will pull the
thread through the needle.
needle threader lever toward the front of the
machine (toward you). The hook will pull the
thread through the needle.
6
Raise the needle threader lever and pull out
about 5 cm (2 inch) of thread through the
needle toward the back of the sewing
machine.
about 5 cm (2 inch) of thread through the
needle toward the back of the sewing
machine.
1
1
2
●
The needle threader can only be used
with home sewing machine needles size
75/11-100/16. Check the table on page
26 for the appropriate needle and thread
combinations. If you are using
transparent nylon mono-filament thread,
you can only use needles in the range of
90/14-100/16.
with home sewing machine needles size
75/11-100/16. Check the table on page
26 for the appropriate needle and thread
combinations. If you are using
transparent nylon mono-filament thread,
you can only use needles in the range of
90/14-100/16.
●
You can not use the needle threader if
you are using decorative threads or
special needles, such as the twin needle
and wing needle.
When using these needles or threads you
will need to thread the needle by hand.
Make sure the main power switch is off
when threading.
you are using decorative threads or
special needles, such as the twin needle
and wing needle.
When using these needles or threads you
will need to thread the needle by hand.
Make sure the main power switch is off
when threading.
CAUTION