Листовка для Chamberlain 956EV Remote Control Security 2.0

Скачать
Страница из 2
4
To exit programming mode, press 
any remote control button except 
the button that was just programmed.
The garage door opener 
will activate.
To test, press the programmed button on the remote control...
Using a safety pin or paper 
clip, press the Program button 
until the LED on the front of 
the remote control turns on. 
1
2
Press and 
release the 
Learn button 
on the garage 
door opener.
Within 30 seconds...
The Learn LED will light.
3
Press and release the remote 
control button you want to use...
Check to see if the garage door opener 
light bulb blinks. If not, wait for the 
remote control LED to light solid then 
slowly press and release the remote 
control button again. Repeat until the 
light bulb blinks. 
DO NOT press the button after the 
light bulb blinks.
5  
NOTICE: To comply with FCC and or Industry Canada rules (IC), 
adjustment or modifications of this receiver and/or transmitter 
are prohibited, except for changing the code setting or replacing 
the battery. THERE ARE NO OTHER USER SERVICEABLE 
PARTS.
This device complies with Part 15 of the FCC rules and IC RSS-
210. Operation is subject to the following two conditions: (1) 
this device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation.
BATTERY
The LED on your remote will stop flashing when the battery is low and needs to be replaced.
To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery 
with only 3V2032 coin cell batteries. Dispose of old battery properly.
To prevent possible SERIOUS INJURY or 
DEATH:
•  NEVER allow small children near batteries.
•   If battery is swallowed, immediately notify 
doctor.
To reduce risk of fire, explosion or chemical 
burn:
•  Replace ONLY with 3V2032 coin batteries.
•   DO NOT recharge, disassemble, heat 
above 212° F (100° C) or incinerate.
1-800-528-9131
114A3924C 
© 2013, The Chamberlain Group, Inc.
 
All Rights Reserved 
REPLACEMENT PARTS
Battery . . . . . . . . . . . . . . . . . . . . . . . . . .  10A20
Visor Clip 
(Models 953EV & 953EVC ONLY) . . . . 29B137
1
2
3
WARRANTY
www.chamberlain-diy.com
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first retail purchaser of this product that is free from 
defect in materials and/or workmanship for a period of 1 year from the date of purchase.
Pry open the case with a screwdriver blade.
956EV & 956EVC
Pry open the case first in the middle (1), then 
at each side (2 and 3) with the visor clip.
953EV & 953EVC
PROGRAM THE REMOTE CONTROL (956EV & 956EVC)