Справочник Пользователя для Brother NV6000D

LOWER THREADING

Ge
tting

Re
ad

Wind the thread clockwise around the
bobbin 5-6 times.

Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread to the right to cut the thread with
the cutter.

a Guide slit (with built-in cutter)
b Bobbin winder seat

Set the bobbin winding switch to the left,
until it clicks into place.

a Bobbin winding switch

o The bobbin winding window appears.

Press .

o Bobbin winding starts automatically. The bobbin

stops rotating when bobbin winding is completed.
The bobbin winding switch will automatically return
to its original position.

CAUTION

• Be sure to follow the process described. If the

thread is not cut with the cutter, and the
bobbin is wound, when the thread runs low it
may tangle around the bobbin and cause the
needle to break.

Memo

• Sliding the bobbin winding switch to the left

switches the machine into bobbin winding
mode.

Note

•

changes to

while the bobbin

is winding.

• Stay near the machine while winding the

bobbin to make sure the bobbin thread is
being wound correctly. If the bobbin thread

is wound incorrectly, press

immedi-

ately to stop the bobbin winding.

• The sound of winding the bobbin with stiff

thread, such as nylon thread for quilting,
may be different from the one produced
when winding normal thread; however, this
is not a sign of a malfunction.

Memo

• You can change the winding speed by

pressing

(to decrease) or

(to

increase) in the bobbin winding window.

• Press

to minimize the bobbin winding

window. Then, you can perform other opera-
tions, such as selecting a stitch or adjusting
the thread tension, while the bobbin is being
wound.

• Press

(in top right of the LCD screen)

to display the bobbin winding window again.