Справочник Пользователя для Siemens 1015N-2MFM-1A

                 2

1015N-2MFM-1A

3.

TECHNICAL SPECIFICATIONS

Interface:

RS-232

Supply Voltage:

5 volts DC

Supply Current:

48 mA

Modem Line Speeds:

2400, 1200 and 300 bps Asynchronous

DTE Rates:

2400, 1200, 300 bps

Modulation:

V.22bis, V.22, Bell 212A, Bell 103

Phone Line:

Dial Up or 2 Wire Leased Line

Extended Hayes Command Set Compatibility
Error Correction / Error Detection: None
Operating Environment:

-40 to 85 degrees C / 0 to 95% Humidity (non-condensing)

4.

1010N FLOWMETER SYSTEM REQUIREMENTS

The System 1010N Flowmeter operating system must be revision level 2.0 or later for the
1015N-2M Modem Card to function properly. In addition, the 1015N-2M Modem Card
requires 1010N system hardware of the following levels in order to work. Refer to the
appropriate 1010N user manual installation/outline drawings for circuit board locations.

a. 1010N-1-5 SysCom Version 3, Revision. D2 or Higher
b. 1010N-2K3 I/O Board A2
c. 1010N-8M-5 I/O Board A3
d. 1010N-7K2 Analog I/O A2

5.

PRELIMINARY INSTALLATION NOTES AND CAUTIONS

CAUTION: It is highly recommended that installation be done in a static free

environment or damage to the 1015N-2M Modem Card may result.

NOTE: The 1015N-2M Modem will not function if the 1010 flowmeter RS-232 port is

connected to the serial port of your PC.

NOTE: The 1015N-2M Modem will only transmit and receive data when used with

direct phone line connections (see paragraph 5.3 below for communication
connection options).

Figure 1. 1015N-2M Modem Card and Attaching Hardware

Top View

Side View

Module ID Label

Captive
Screws (4)

1015N-2M
Modem Card

TB1 Network Connection
(2-Wire Hook Up)

Con 2 Network Connection
(RJ11 Connector)