Листовка для Omega Speaker Systems Metal Liner and Decorative Wood Hood

Before installation may begin, the following components are required:

                                         • Fan unit, part number 90026WHI1

                                         • Blower unit, part number 90039WHI1

                                         • Ducting System  •  Metal Liner  •  Decorative Wood Hood

      1.

The decorative Hood Front.

      2.

Optional galley rail  (shipped unattached).

      3.

T-shaped Metal Liner, Figure 2.

NOTE:

T-shaped liner shipped with unit as standard. Rectangular

shaped metal liner available for on-site Wood Hood construction, Fig-
ure 4.

      4.

The ventilation system (power module and ducting system) is

                 not included and must be purchased separately.

      1.

Measure up 6 1/8 from the bottom of adjacent cabinets. Scribe
a level line horizontally across depth of both cabinets.

      2.

Raise Metal Liner so that bottom edge of liner is level with
scribed lines. Use four (4) #8 x 1/2” screws provided to attach
liner to adjacent cabinets through pre-drilled holes in liner. (If
metal liner is not flush to cabinet sidewalls, it may be neces-
sary to use a filler piece to avoid bowing the liner.) Locate
studs and place two #8 x 1 1/4”, supplied, through rear of
liner.

      1.

Slide decorative hood front into position over T-Shaped liner
and between adjacent cabinets. Install the hood front by ad-
joining to adjacent cabinets through the front frames using (4)
#8 x 2 1/2” screws (not provided).

       

 Form OME-03 12/2002                                                                                                       ©2002 Omega Industries, Inc.

Figure 1

Figure 2

Figure 3