Справочник Пользователя для Smart Inventions HAWM-UX/UF

CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF

 

Connecting your SMART UF65 and SMART UF65w projector 
to the pen tray audio jack

The audio and power jacks are located beside each other on the back of the pen tray.

1. Connect the ends of the stereo Y cable to the VGA 1 and the VGA 2 inputs on 

your UF65 or UF65w projector.

2. Connect the other end of the stereo Y cable to the audio jack on the back of your 

interactive whiteboard’s pen tray.

Connecting your SMART UF65 or SMART UF65w projector 
to the SBA-L projection audio system

HAWM-UX/UF is designed to accommodate mounting the SBA-L projection audio 
system directly to the interactive whiteboard. That way, when the speakers rise and 
descend with the HAWM-UX/UF’s and interactive whiteboard’s movement, there’s 
less risk of damage to the audio connection and power cables. Therefore, SMART 
recommends that you don’t mount the SBA-L projection audio system to the wall.

Before connecting the audio system to the projector, you must install the speaker 
brackets, speakers and speaker cable clips according to the SBA-L Projection Audio 
System Installation Instructions (

). 

1. Retrieve the 3.5 mm jack to dual channel audio output (two RCA jacks) cable from 

the SBA-L packaging. 

2. Pass the audio connection cable through the boom. Place the cables in the left 

side of the cable slot.

3. Connect the audio connection cable to the projector’s connection panel.