Листовка для SmartLabs Pill Reminder Device 2484D

Page 1 of 2 
Rev. 121307 

 
KeypadLinc

TM

 - INSTEON 8 Button Countdown Timer 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
KeypadLinc INSTEON Countdown Timer is a general purpose, countdown timer with 7 or 8 timer 
durations. Like other countdown timers, it will turn the connected lights / circuit off when its timer 
expires. However, that’s where the similarity ends. Countdown Timer can also turn other 
INSTEON devices off when its timer expires. Still further, when you Link other INSTEON devices 
(as a Controller) to Countdown Timer, it will automatically start its countdown timer for the amount 
of time you choose. 

1) 

Tap the “5 min” button (this will turn your lights on for 5 minutes) 

 

 

2) 

To turn lights off at any time, tap the OFF button or the button whose LED is on 

 SET 

Button 

Important: Installation should be performed only by a qualified electrician or by a homeowner who is familiar and comfortable with electrical circuitry. If there are any questions, consult an electrician. For 
setup questions contact Tech Support at SmartLabs for guidance. Tools required: Phillips screwdriver, slotted screwdriver and a wire cutter/stripper. Two or more properly installed INSTEON Access 
Points are strongly recommended for every home to ensure reliable communication. You will need to ID all your wires before beginning. For a wiring diagrams (including 3-way circuits), see the 
KeypadLinc Dimmer Owner’s Manual at 

http://www.smarthome.com/2486D.pdf

.  

 

1) 

Disconnect power at the service panel 

2) 

Remove trim plate and existing switch/dimmer 

3) 

Connect Countdown Timer’s copper wire to ground with a wire nut (or screw as appropriate) 

4) 

Connect Countdown Timer’s white wire to neutral with a wire nut 

5) 

Connect Countdown Timer’s black wire to hot wire with a wire nut 

6) 

Connect Countdown Timer’s red wire to the switch-leg with a wire nut (control of a local load is optional) 

7) 

Carefully screw Countdown Timer into electrical box and replace trim plate 

8) 

Restore power at the service panel 

 

9) 

Test Countdown Timer by pressing the “2 min” button  

 

1) 

Press & hold the corresponding button on Countdown Timer until its LED begins blinking 

2) 

Press & hold the same button again – hold it for 15 seconds 

3) 

Press & hold the  SET button on the INSTEON-compatible Responder you wish to remove from Countdown Timer until its LED flashes  

Note: for multi-button devices, press & hold the button of choice until LED / load flashes 

 

 

1) 

Press & hold any button on Countdown Timer until its LED begins blinking 

2) 

Press & hold the SET button on the INSTEON-compatible Responder you wish to control until its LED flashes  

Note: for multi-button devices, press & hold the button of choice until LED / load flashes 

Note: All the devices you link in this manner will be turned on when you turn Countdown Timer on and will turn Off when the timer 
expires.