Справочник Пользователя для Electrolux OHV
42
43
7.51 Remove Chute Assembly for
servicing other items
servicing other items
1) Remove spring that attaches from the
deflector to the pivot.
NOTE: If unit is not equipped with a remote
deflector proceed to step 4
2) Remove the nut and washer that secures
deflector proceed to step 4
2) Remove the nut and washer that secures
the deflector cable to the deflector.
3) Remove the nut, washer and bracket that
secure the cable to the chute.
4) Remove the 9/16" locknut and separate the
cable assembly from the chute assembly.
The chute assembly will separate,
be careful not to drop the chute onto the
snowthrower.
The chute assembly will separate,
be careful not to drop the chute onto the
snowthrower.
5) Reverse process to reinstall chute deflector.
7.61 Remove Auger Assembly for
servicing
servicing
1) Remove spark plug wire from plug.
2) Remove Deflector Chute (Section 7.51
2) Remove Deflector Chute (Section 7.51
Chute Removal)
3) Remove both 3/8
"
screws that secure belt
cover. Remove belt cover.
4) Place a chair or saw horse behind handle
assembly for support after auger section is
split.
split.
5) Remove both 9/16
"
hex bolts that hold the
powerhead and auger housing together.
To Reinstall:
7) Place belt on auger pulley and use to lift
7) Place belt on auger pulley and use to lift
auger assembly into position so that slotted
bracket on auger housing are placed onto
the rod at base of powerhead.
bracket on auger housing are placed onto
the rod at base of powerhead.
9) Route auger belt around pulleys/guide.
Check that belt is not caught on idler brkt.
10)Reinstall bolts to secure auger housing to
the powerhead and belt cover.
11)Reinstall the chute assembly and plug wire.
CABLE
ASSEMBLY
ASSEMBLY
9/16" LOCKNUT
RIGHT SCREW
LEFT BOLT
RIGHT BOLT
SPRING
DEFLECTOR
CABLE
CABLE
NUT AND
WASHER
WASHER
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com