Справочник Пользователя для Force10 Networks Force10 TeraScale E-Series E1200i

Installing and Maintaining the E1200i System

63

After you supply power to the system, the following should occur:

•

During bootup, power is removed temporarily from all line cards and SFMs. This is expected behavior.

•

Both fan trays should be operating. 

•

The green (online) LEDs for the fan trays, Power Supplies, RPMs, SFMs, and line cards should be lit 
and remain lit as long as the system is receiving power and is operational. 

When you supply power to the E1200i system, the system performs a series of power-on self tests. RPM, 
line card, and SFM LEDs blink as the diagnostic programs run. No user interaction is required at this point. 
Observe the process on your console monitor. When the boot process is complete, the card LEDs remain 
online (green) and the console monitor displays the Command Line Interface (CLI) prompt. 

Refer to the 

, on the technical publications CD-ROM, for initial configuration 

procedures and configuration instructions. 

The initial boot operation automatically brings up the system to the runtime CLI. To interrupt the 
automatic boot process, issue a break key sequence (CNTL^). The console monitor will display the default

 

BOOT_USER # 

prompt. Refer to 

 for instructions to continue the boot process.

Note: Do not press any keys or control sequences at any time during the boot process. Doing so may cause 
the boot process to terminate.