Справочник Пользователя для Falcon NAVI-B

NAVI-B VERSION 

1.01 

 

Before using the NAVI-B, make sure to prepare following: 

♦  A GPS software is properly installed on your Bluetooth™-enabled 

device (PC, laptop, PDA, or other handheld devices). 

♦  The Bluetooth™ GPS Receiver is fully powered and operational. 

♦  Check that the Bluetooth™ GPS Receiver is ON. 

This section will outline the procedures necessary for the Bluetooth™ GPS 
receiver to run smoothly with the GPS software. 

The position of the antenna mounting is crucial for an optimal performance 
of the GPS receiver. The antenna must have full view to the sky ensuring a 
direct line-of-sight with as many visible satellites as possible. 

a)  Use the enclosed cleaning cloth. Clean the side of the part, where the 

receiver is supposed to be installed. Note that, the length of extended 
cable of the NVAI-B is 2.5 m. 

b)  The signal receiving side is on the bottom of NAVI-B. 
c)  There are an adhesive pad and a Velcro pad included, required for on-

glass mounting. Both pads contain two mounting surfaces. One of 
them has to be stuck on the bottom side of the receiver and the another 
one on the cleaned area. Both surfaces of pads are protected by 
stickers.   

d)  Remove the protecting sheet from one surface of pad. Mount that 

surface onto the bottom side of receiver. Remove the other protecting 
sheet from mounted adhesive or Velcro pad (which is required to be 
used). Place the bottom side of NAVI-B onto cleaned area and press 
the NAVI-B to avoid air bubbles between contact surfaces. The 
Velcro pad can also be separated in two parts. 
Hints 

Proper functionality requires on-glass-mounting 

♦ 
♦ 

♦ 

♦ 

Do not install the device on metallic or coated windows 
To be installed in-door on the immovable parts. 
NAVI-B is not water resistant. Do not contact it with water. 

This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. 

Page 12