Справочник Пользователя для Diamond Power Products Saw CC500M

 
 
5.  For Saws With Electric Motors: 
 

Connect motor to a properly grounded outlet.  Motor may be operated on 115 or 230 
volts.  Set switch on motor capacitor housing to match desired voltage.  Plug on 
motor cord must also be changed to match correct voltage. 

 

 
Proper voltage is critical for proper motor performance.  Extension cords which are too 
long and/or too small of a gauge will prevent motor from receiving full voltage.  Follow 
extension cord recommendations below: 
 

 
 

50 

FT. 

#12 #14 #10 #14 

75 

FT. 

#12 #14 #10 #14 

100 

FT. 

#10 #14 #8 #12 

 

 
Turn switch to “ON”  position to start electric motor.  If motor overheats, the manual reset 
thermal overload will trip.  Turn motor off, wait 5-10 minutes for motor to cool, and push 
reset button on capacitor housing.  Button clicks to indicate that motor is reset. 
 
For saws with gas engines: 
Check engine oil level before starting.  Start engine and allow it to warm up according to 
engine manual instructions.  After engine warms up, all sawing is done at full throttle.   
 
 
To cut material, either: 
a)  Pull cutting head down by handle to desired cutting depth.  It is best to use the entire 

diamond segment height to cut.  Tighten handle on depth lock to keep cutting head 
at set height.