Инструкции Пользователя для Bunn ICB Tall

Page 12

The information is loaded into the brewer’s memory 

by holding the chip area up to the brewer’s SENSING 

COIL.  

NOTE: Instructions to program the brewer are printed 

on the AD CARD.

1.  Remove the funnel(s) if present.

2.  Position the RECIPE CARD vertically, so that the 

top end of the CHIP is beneath the (Left on Twins) 

SENSING COIL (located on the underneath side of 

the front display panel).

3.  After a short pause the display will read CARD 

CONTAIN ADS/SHOW-QUIT-SAVE.

4.  To show (view) this information, select "SHOW". 

The display will scroll through all of the ad on that 

chip. The display will then return to CARD CONTAIN 

ADS/SHOW-QUIT-SAVE.

5.  If message is correct, press SAVE. The display will 

read AD MESSSAGE SETUP COMPLETE.  The ad is 

now stored in the brewer’s memory.

6.  If the ad is not correct, or it is desired to exit the 

setup before the ad is loaded into the brewer’s 

memory, press QUIT. The display will then return 

to the MAIN SCREEN.

POSITION CARD UNDER

SENSOR COIL

SCROLLS THROUGH 

COMPLETE MESSAGE

NOTE: ENABLE ADS must be 

turned on in LEVEL 2 in order 

for the newly programmed ad 

message to be displayed.

41581.3 120210