Справочник Пользователя для Braun Flex Integral 5525

 

4

 

4

 

5

Switch positions:
0 = Off (when not in use and always when charging)
1 = Shaving with the twin foil 

 

H

 

 and the integrated 

longhair cutter 

 

h

 

2 = Shaving with the pivoting head locked at an 

angle to permit shaving under the nose or at the 
hairline

3 = The longhair trimmer 

 

5

 

 is activated

 

The LCD displays 

 

2

 

 and 

 

3

 

 show the state of the 

shaver and the rechargeable cell unit.

The rechergeable cell unit is discharged. The shaver 
is not in operation.

The cell unit is charged between 0 and 99 %; the 
shaver is connected to the mains and the plug 
symbol is visible on the display with a green frame 

 

2

 

. Should charging be interrupted during the 

charging phase, the plug symbol flashes on the 
display, thus reminding you to continue charging.

The shaver is connected to the mains – the plug 
symbol is visible on the green framed display. After a 
recharging time of approximately 1 hour, the battery 
symbol is also visible on the green framed display. 
The cell unit is recharged to 100 %.

The cell unit is charged between 100 and 20 %; the 
shaver is not connected to the mains. Whether 
switched on or off, the battery symbol is visible on the 
green framed display.

The remainging charge in the cell unit is between 20 
and 0 %. The shaver is switched on or off, however, 
not connected to the mains. The battery symbol 
flashes on the red framed display 

 

3

 

 – thus showing 

the remainging charge – until the cell unit is fully 
discharged.

 

The shaver was delivered with the switch lock 
activated (position «

 

 lock»). Push the switch lock 

 

k

 

 

to position «

 

» before you shave for the first time. To 

avoid accidentally switching on the shaver, push the 
switch lock to position «

 

 lock».

 

When charging the shaver for the first time, connect 
it to the mains (100 - 240 V) and charge it for 4 hours 
to full capacity. Then discharge the shaver through 
normal shaving until the display 

 

3

 

 flashes. 

Recharge the shaver for at least 1 hour until the 
black battery symbol appears in the display 

 

2

 

. 

This charging method preserves the maximum 
capacity of the cell unit. All subsequent charges will 
also take only 1 hour (quick charging). The full 
capacity is reached after several charge/discharge 
cycles. The shaver automatically adapts to all direct 
and alternating current voltages (12 - 240 V) and to 
frequencies of 50 or 60 Hz. Recharging on 12 V (–) 
in cars or boats, takes approximately 20 hours. The 
surrounding temperature should not exceed + 25 °C.

A full charge will give up to about 70 minutes of 
cordless shaving (approximately 20 days based on 
3.5 minutes per shave), depending on the thickness 
of your beard.

In order to maintain the maximum capacity of the 
rechargeable cell unit, it should be discharged about 
every 6 months by shaving. Then fully recharged for 
approximately 4 hours from the mains. Do not keep 
the shaver connected to the mains for a long period 
of time (i. e. several weeks).

Connect the shaver to the mains and turn the shaver 
on (see switch 

 

4

 

). If the shaver should not run 

immediately – because of the discharged cell unit – 
leave it plugged in with the switch 

 

4

 

 set to «0», for 

approximately 1 minute. Thereafter, you can shave 
with cord plugged into the outled.

Notice: Shaving directly via the cord on voltages 
below 100 V (in cars, boats etc.) is not possible.