Справочник Пользователя для MAC Tools Refrigerator ACL2500

All Systems -
8. Following any service to the refrigerant system and any other service which dis-

turbs the refrigerant system, a leak test of the repair and of the service ports of
the refrigerant system should be done.

The ACL2500 Leak Detector may also be used to:

•

Detect leaks in other systems and storage/recovery containers. It will respond to

ALL halogenated (contains Chlorine or Fluorine) refrigerants. This includes, but
is not limited to:

CFCs

e.g. R12,R11,R500,R503 etc...

HCFCs

e.g. R22,R123,R124,R502 etc...

HFCs

e.g. R134a, R404a, R125 etc...

Blends such as AZ-50, HP62, MP39 etc...

•

Detect Ethylene Oxide gas leaks in hospital sterilizing equipment (it will detect

the halogenated carrier gas)

•

Detect SF-6 in high voltage circuit breakers

•

Detect most gases that contain Chlorine, Fluorine and Bromine (halogen gases)

•

Detect cleaning agents used in dry cleaning applications such as 
perchloroethylene

•

Detect Halon gases in fire extinguishing systems

Proper maintenance of your Leak Detector is very important.  Carefully following the
instructions, outlined below, will reduce performance problems and increase the life
expectancy of the unit.

TURN UNIT OFF BEFORE REPLACING THE SENSING TIP.

FAILURE TO DO SO MAY RESULT IN A MILD ELECTRICAL SHOCK!

Keep the sensing tip clean:  Prevent dust, moisture  and grease build-up by utilizing
the provided tip protector. Never use the unit without the protector in place.

Before using the unit  always  inspect the tip and protector to see that they are free
of dirt and/or grease. To clean:

1.  Remove protector by grasping and pulling off  tip.

2.  Clean protector with shop towel and/or compressed air.

9