Справочник Пользователя для LOEWE Connect 32

Скачать
Страница из 64
11 -
Installing the TV set
Install as manually rotatable table unit with the Table Stand included.
See accessories (page 58) for other installation options.
Preparing the remote control unit
Inserting or replacing batteries
Press the embossed arrow and push down the 
battery compartment cover.
Insert two alkaline manganese LR 03 (AAA) batteries; 
ensure that the + and – poles are correctly positioned!
Slide the cover up from below.
Adjusting the remote control for operating the TV set
Press the TV button.
See page 52 to find out how to operate other Loewe 
equipment.
Initial installation
AAA
  LR03
AAA
  LR03
Connecting the TV set
Connecting to the mains
Connect the TV set to a 220-240V power outlet:
First plug the small plug of the power cable into the 
power connection on the rear of the TV, then plug the 
large power plug into a mains power outlet. 
Connecting the antenna
Analogue / DVB-C- / DVB-T antenna:
In sets with DR+: Plug the antenna plug of the antenna 
or cable system or the room antenna into the ANT2 
socket. The connecting cable between ANT-TV and ANT 
OUT has already been plugged in at the factory.
In sets without DR+: Plug the antenna plug of the 
antenna or cable system or the room antenna into the 
ANT-TV socket.
Satellite antenna, if upgraded:
Connect one antenna plug each, for example, from 
the antenna switch or the Twin-LNC of the satellite 
system to the ANT-SAT and ANT-SAT2 sockets (only for 
sets with DR+). If you only connect one SAT antenna 
cable, connect it to ANT-SAT.
Connections on the back of the set (see also page 5 and 6).
Connect network (only for sets with Network Mediaplayer)
Connection and configuration of the network connection is 
described in the Network Mediaplayer operating manual.
Receiving coded stations
When using a CA module and a Smart-Card to receive 
coded stations, please observe the handling of the CA 
module (see page 34).
TV
R
ANT
SAT
ANT2
ANT
SAT2
220-240V~
50/60Hz
ANT-TV
ANT
OUT